See the Soft Start Module  Product Review on the Rotax-Owner.com website!

HAVE YOU HAD ANY PROBLEMS WITH YOUR ENGINE KICKING BACK DURING START UP?

The Soft Start Module (SSM) alters the timing on one ignition circuit. It has been found to be highly beneficial on 912ULS engines fitted with a slipper clutch.
The real cause of these problems is inadequate batteries and long starter cables resulting in slow cranking speeds. The Soft Start Module helps overcome the problems caused by these short falls.

Features:
Fully solid state.
Fully automatic, the soft start module is triggered by each attempt to start the engine.
4 pin and 6 pin options available to accommodate the two different types of connectors found on the Rotax 912 & 914 series engines..

Safety Features:
Single Mag ignition circuit installation, leaving the other circuit to operate as normal.
Twin parallel circuits for added safety backup.
Available with either a 6 way plug or 4 way plug configuration to fit the type used on your engine. In order to determine which plug configuration you need to order, you will need to locate the part number on the Rotax Electronic Module fitted to your engine.

Please see the picture on the left to locate your Electronic Module Part Number.
(click on the picture to enlarge).

For a copy of the Installation Instructions, click here

In cases where the soft start does not correct your starting problem, you may have already managed to damage the Sprag Clutch or your Gearbox Friction Torque is too low.

back